AAA configuration on Cisco Router

Basic AAA configuration on Cisco Router

AAA stands for Authentication, Authorization and Accounting. It is a framework which controls the user access on the devices.

Authentication: It is used to check the identity of an user. It helps us in identifying the users and accordingly we can give access to them

Authorization: It controls the device access as per the user skill level. What access is given to which user. With this we can control access level of different users.  

Accounting: It is primarily used to log the activity of the users. This is very useful in auditing and billing purpose.

  Below are the AAA configuration on Cisco router and switches using Tacacs server. It doesn’t include the ACS configuration, it just explains the configuration required on the router and switches.

Step 1: Configure the Backup credentials. AAA doesn’t mean that we don’t require local credential. It is mandatory to have backdoor credentials so that we can access the devices when our AAA servers are down or unreachable.

Router(config)#username Admin password PowerKey

 Step 2: Configure Tacacs servers. We can configure multiple Tacacs server.

Router (config)#tacacs-server host 192.168.1.10 key mySecretkey1 Router (config)#tacacs-server host 192.168.1.11 key mySecretkey2

Step 3: Choose the correct interface to be a source of Tacacs packet. It may create problem if we have multiple interface configured on a router. Choose the interface which has the same IP as in AAA server.

Router (config)#ip tacacs source-interface loopback 0

Step 4: Check reachability of Tacacs server from router. If there is a firewall between the router and tacacs server then make sure that TCP port 49 is opened to allow tacacs traffic.

Router #ping 192.168.1.10   Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 10.0.0.2, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms

Step 5: Enable AAA on router globally.

Router (config)#aaa new-model

Step 6: Configure the Authentication methods. Below command is applying authentication on router login. Default keyword applies the method on all lines.

Group tacacs+ sending the authentication request to all configured AAA servers.

LOCAL keyword specifies that in case all of the configured tacacs servers become unreachable, user will be authenticated using local user database. This fail back mechanism is not applicable if the TACACS server is reachable via ping but not handling the request may be because of wrong KEY configured on device or due to internal ACS problem.

ROUTER(config)#aaa authentication login default group tacacs+ local

Step 7: It authorize all the commands entered in Config mode.

Router(config)# aaa authorization config-commands

Step 8: It checks the privilege level of the user from AAA server. Without this command user will login in user mode only.

Router (config)# aaa authorization exec default group tacacs+ local if-authenticated

Step 9: Below command provides authorization to the privilege 1 user.

Router (config)# aaa authorization commands 1 default group TACACS+ if-authenticated

Step 10: Below command authorize the Level 15 users. Each time user run a command, switch send the query to Tacacs server to check if the user is authorize for it.

Router (config)# aaa authorization commands 15 default group TACACS+ local if-authenticated

Step 11: It enable the accounting on all lines.

Router(config)# aaa accounting exec default start-stop group tacacs+

Step 12: It logs all the activity of level 1 user.

Router(config)# aaa accounting commands 1 default start-stop group tacacs+

Step 13: It logs all the activity of level 15 users.

Router(config)# aaa accounting commands 15 default start-stop group tacacs+

Step 14: Applying AAA authentication on VTY lines.

Router(config)# line vty 0 15 Router(config-line)# login authentication default

Step15. Verification: Try to access the device using Tacacs credential